Service telephoneThe pig scalding pool is made of stainless steel with thickened inside. Using 304 seamless heating tube, the heating effect is not easy to damage. The size of the pool can be customized according to the number of processing objects and the number of one-time delivery, and the power used depends on the size of the pool. The premise is to make sure that the power of the cable in the place where the scalding pool is used can reach the bearing capacity and above, so as to prevent the occurrence of electric danger.
Precautions for pig scalding pool:
1. Before using the equipment, please reconfirm that the power of your customized ironing pool is consistent with the square number of cables in your field, and can't be lower than the square number of the required ironing pool.
2. Before using the ironing bath, please tighten the wiring parts again to prevent bumping during transportation and loosening the joint.
3. After all confirmed, add water to the scalding pool, submerge the heating tube, and do not let the heating tube dry burn. It is tap water or light water to prevent scale from growing too fast and damaging the heating pipe.
4. It is suggested that the scalding pool should be cleaned and nursed after killing pigs every day, especially the heating tube, and the scale should be removed with a small brush to prolong the service life.
5. Hot pool distribution box has a heating tube and two heating tubes, two heating tubes can be opened at the same time, or one can be opened after heating for heat preservation, which is convenient to save electricity.
6. There is a time regulator in the power distribution box. Set the time regulator to start heating at a certain time every day. Later, it will remember the time and heat on time. Instructions are enclosed.
7. The distribution box has a temperature control instrument panel, which usually displays the real-time temperature. When the "set" key is pressed, it is used to adjust the temperature to be heated Key means to raise the temperature to be heated, and key means to lower the temperature to be heated. After setting, press the "set" key again to complete the operation.